| Recent Answers |
 |
|
2008-10-04 Boat Repair - mercr. i/o: the gimbal bearing and u-joints are the problem.. Pull the stern drive off and inspect and or replace the u-joints and or gimbal bearing..With the drive off you can look right at the bearing in the transom...
|
2008-10-01 Boat Repair - Power Trim 1997 Evinrude 150 hp Ficht: yes you have to pull the moto, to get to the last bolt...with the manual release loosened you should be able to but you should be able to get to them with the motor off ...never tryed to raise on manualy...
|
2008-09-30 Boating - water in gas: Hi Jamie...Thank you for selecting the undersigned to reply to your question. Fortunately, it's not the engine that's the problem. I'm not an expert on water but it seems to me contaminated fuel...
|
2008-09-24 Boating - prevent roting during winter: Hello again Ever...and thanks for clarifying a few aspects. I'm surprised to hear a 13yr. old starcraft would have such a problem. Perhaps the plywood is not marine grade, meaning the glue that secures...
|
2008-09-23 Boat Repair - tilt/trim 1984 suzuki dt115 2 stroke: do you hear a click???? check your positive connections..if that is ..should be positie on one side for both up and down relays ..the other big wire goes to the trim motor one small wire for rach relay...
|